Page 1 of 1116/03/05MFK560C153, MFK560C168 AND MFK560CDCHEVY V8 PETROL AND DIESELTOLANDCRUISER 3, 4 & 5 SPEED PETROL TRANSMISSIONSFitting Instruct
Page 10 of 11NOTE: The input shaft extension shown in the diagram above will only suit the spigotbearing support (6202) which is a ball race used with
Page 11 of 1113. Complete the exhaust system. NOTE: Heat shields must be fitted to the exhaustsystem to prevent excessive heating of the engine
Page 2 of 113F fitted with the Two-piece aluminium bellhousing and cast iron sandwich plate.1. Undo the front engine mounts.2. Support the transmissio
Page 3 of 11Slide the thrust bearing extension carrier through the inside of the adaptor housing.Ensure that the tube slides in
Page 4 of 11Diagram A.E.1F, 2F, and early 3F fitted with the one-piece cast iron bellhousing.1. Fit the adaptor housing assembly to the Toyota petrol
Page 5 of 11Refer to diagram B and C. This operation requires the slave cylinder push rod and clutch fork to be fitted.6. Push the thrust bearing and
Page 6 of 11Diagram B.AC
Page 7 of 11F.3F fitted with the Two-piece aluminium bellhousing and cast iron sandwich plate.1. Fit the adaptor housing assembly to the sandwich plat
Page 8 of 11H.Engine Mount Set UpThe most accurate way of determining the position of the new mounts is to trial fit theengine.NOTE: If this engine ki
Page 9 of 11 5. Fit the Toyota oil pressure and temperature senders to the engine using the adaptorssupplied.J.Final Adaptor Preparation 1. Refer to
Commentaires sur ces manuels