ADVANCE ADAPTERS INC. P/N: 713094
P.O. Box 247, 4320 Aerotech Center Way New Item: (08/02)
Paso Robles, CA 93447 PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-10-08
KIT CONSISTS OF:
No. Qty Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
1. 1 713008-NS RUBBER MOUNTS
2. 1 713094L LEFT MOUNT
3. 2 713094M BLOCK MOUNTS
4. 1 713094R RIGHT MOUNT
5. 4 713094S DRIVER SIDE SPACER FOR 360 ENGINES
6. 8 724301 NYLON LOCK NUT 7/16"-14
7. 16 724302 FLAT WASHER 7/16"
8. 4 724308 H.H.C.S. 7/16"-14 x 1-3/4"
9. 4 724309 H.H.C.S. 7/16"-14 x 2"
DODGE V8 WELD-IN MOUNTS
1997-06 JEEP TJ
INSTALLATION PROCEDURES:
This mount kit is designed as a weld-in application. Cutting, grinding, and welding is required. These mounts can
be used when replacing both a stock 6 cylinder or 4 cylinder engine.
To install a Dodge V8 into a Jeep TJ, we recommend that the entire front clip of the vehicle be removed for ease
of installation. This would also include the hood, grille, both fenders, and miscellaneous components. Some of the
components in the engine compartment may need to be relocated (i.e. smog equipment, battery, radiator, overflow,
etc.). Once the stock engine has been removed, you'll be ready to begin the new engine installation.
Bolt the block mounts to the block using the hardware given. Take note of the thicknesses of each boss and use
the correct length bolt accordingly. Also, one of the bolts may not be used on the block because some Dodge blocks
have only 3 holes on one side.
Grind or torch off the stock frame mounts.
Grind off all the welds, and make the frame
rails smooth. Next, identify the holes on
each side of the frame which you will use
to locate the mounts. They are located on
the inside of the frame, about 23" away
from the front crossmember. Using the
bolt that protrudes from the frame mount
as a alignment pin, C-clamp the mounts to the inside of the frame (the
front-to-back angle of the mounts will be determined later). Place the
engine in the engine compartment and align the holes from the block
mounts to the frame mounts. Rotate the doweled frame mounts so they
hit parallel to the engine mounts. Tighten the C-clamp and/or tack weld
them in place. Remove the engine assembly and full-weld the mounts to
the frame.
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels